Outer CV Joint, Checking
The joint is to be disassembled if badly contaminated to replace the grease, or when the ball contact surfaces show wear or damage.
Disassembling
-- Mark the position of the ball hub -2- to ball cage -3- and to housing -1- before disassembling, using an electric engraver or grindstone.
-- Tilt the ball hub and ball cage.
-- Remove the balls one after the other.
-- Turn cage until the two rectangular windows -arrow- are aligned with the joint housing.
-- Lift out cage with hub.
-- Tilt the hub segment with shorter pins into rectangular window on the cage.
-- Fold hub out from cage.
Checking
The balls for each joint belong to one tolerance group. Check the axle stub, hub, cage and balls for small depressions (pitting build-up) and chafing. Excessive backlash in the joint is noticeable by a thump during load alternations. The joint should be replaced in these cases. Flattening and running marks on the balls are no reason to replace a joint.
Assembling
-- Insert cage with hub into joint body.
- The cage must be inserted on the correct side.
-- Press in the opposite facing balls one after the other, and the old ball hub position to the ball cage and to the joint housing must be replicated.
-- Press the grease into the joint body. Refer to Grease Quantity and Type .