Drivetrain Control Module - J775-, REMOVING AND INSTALLING, AUDI Q8: Installing

Install in reverse order of removal and note the following:

-- After installing a new Drivetrain Control Module -J775- activate the control module.

-- Connect the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start the Diagnostic operating mode.

-- Select the Test plan tab.

-- Select the Select individual test button and select the following tree structure consecutively:

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.

-- Readapt the standard vehicle height. Refer to STANDARD VEHICLE HEIGHT, READAPTING .