Tie Rod, Removing And Installing: Removing
- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
-- Remove the boot. Refer to BOOT, REMOVING AND INSTALLING .
-- Position the front wheels as follows:
- For the left tie rod, turn the steering to the left until it stops
- For the right tie rod, turn the steering to the right until it stops
-- Unscrew the tie rod with the :VAG1923 -2-. Counterhold the steering gear steering rack with an open end wrench -1- while doing this.
CAUTION:
There Is a Risk of Destroying the Steering Gear If the Boot Is Faulty.
Moisture and Dirt Could Enter.
- Check the splines on the steering rack for a visible lubricating film.
- If the film of grease is missing, replace the steering gear.