Rear Thorax Airbag With Igniter, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
- Pay attention to the safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
-- Remove the used clip from the side cushion bracket.
-- Press the new clip into the side cushion bracket until it clicks into place.
Pyrotechnical components can deploy unintentionally.
Risk of injury.
- Discharge the static electricity: quickly touch the door striker.
-- Connect the connector -1- to the airbag igniter direction of the -arrow A-.
-- Press in the connector lock -2- in the direction of the -arrow B-. At the same time, the connector is pushed into the airbag igniter all the way and locks into place.
- Make sure the wires are not pinched.
-- Insert the side cushion and press in the wire frame forcefully into the clip.
-- Make sure the wire hook engages correctly into the clip.
Risk of airbag deployment.
Risk of injury.
- Switching on the ignition (key/button) after assembly may only be done when the driver seat is positioned all the way back.
-- Check and erase the airbag control module DTC memory because faults can be stored from when the connectors are disconnected. Use the Vehicle Diagnostic Tester.