Driver Front Airbag Crash Sensor -G283-, REMOVING AND INSTALLING: Installing
Install in the reverse order of removal while noting the following:
- Pay attention to the safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
-- Connect the connector -1- to the crash sensor until it clicks into place in the direction of the -arrow-.
-- Push in the connector lock -2- to secure the connector.
CAUTION:
Risk of airbag deployment.
Risk of injury.
- Switching on the ignition (key/button) after assembly may only be done when the driver seat is positioned all the way back.
-- Check and erase the airbag control module DTC memory because faults can be stored from when the connectors are disconnected. Use the Vehicle Diagnostic Tester.