Luggage Compartment Cover Drive Unit -VX68-, REMOVING AND INSTALLING: Removing

-- Remove the luggage compartment floor. Refer to LUGGAGE COMPARTMENT FLOOR, REMOVING AND INSTALLING .

-- Remove the lock carrier trim panel. Refer to LOCK CARRIER TRIM PANEL, REMOVING AND INSTALLING .

-- Remove the luggage compartment side trim panels. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .

-- Release and disconnect the connector -arrow-.

Fig 1: Roll Cover Motor Nuts And Bolt Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Slightly lift the left and right supports for the luggage compartment floor.

-- Remove the nuts -1- and bolt -2-.

-- Remove the nut -2- and bolts -3 and 4-.

Courtesy of AUDI OF AMERICA, LLC

-- Unclip the release cables from the brackets -arrows-.

-- Repeat the process on the opposite side.

-- Disengage and remove the guide rails -1- with the roll cover motor.