Coolant Pipes On SUBFRAME, Transmission And Body

The marking on the coolant pipes and ends of coolant hoses must align.

Fig 1: Exploded View Of Coolant Pipes On Subframe, Transmission And Body

Courtesy of AUDI OF AMERICA, LLC

1. Right Front Coolant Pipe in Wheel Housing
   • Removing and installing. Refer to RIGHT FRONT COOLANT PIPE IN WHEEL HOUSING, REMOVING AND INSTALLING .
2. Bolt
   • 8 Nm
3. Spacer Sleeve
4. Rubber Bushing
5. Flange Nut
   • 8 Nm
6. Nut
   • 8 Nm
7. Double Bolt
   • Tightening specifications. Refer to OVERVIEW - SUBFRAME .
8. Left Coolant Pipe on Subframe
   • Removing and installing. Refer to LEFT COOLANT PIPE ON SUBFRAME, REMOVING AND INSTALLING .
9. Bolt
   • 8 Nm
10. Rubber Bushing
11. Spacer Sleeve
12. Bolt
    • 8 Nm
13. Coolant Pipe to Lock Carrier
    • Removing and installing. Refer to COOLANT PIPE TO LOCK CARRIER, REMOVING AND INSTALLING, VEHICLES WITHOUT AUXILIARY RADIATOR FOR TRANSMISSION FLUID COOLING .
14. Rubber Bushing
15. Spacer Sleeve
16. Bolt
    • 8 Nm
17. Nut
    • 5 Nm
18. Right Rear Upper Coolant Pipe on Longitudinal Member
    • Removing and installing. Refer to RIGHT REAR COOLANT PIPES ON LONGITUDINAL MEMBER, REMOVING AND INSTALLING .
19. Nut
    • 5 Nm
20. Nut
    • 5 Nm
21. Right Rear Lower Coolant Pipe on Longitudinal Member
    • Removing and installing. Refer to RIGHT REAR COOLANT PIPES ON LONGITUDINAL MEMBER, REMOVING AND INSTALLING .
22. Right Coolant Pipe on the Transmission
    • Removing and installing. Refer to RIGHT COOLANT PIPE ON TRANSMISSION, REMOVING AND INSTALLING .
23. Bolt
    • 8 Nm
24. Bolt
    • 8 Nm