HEATER AND A/C UNIT, REMOVING AND INSTALLING, "Mid" OR "Mix" A/C SYSTEM, PR NUMBER KH5/ 9AU: Installing

Install in reverse order of removal and note the following:

-- Check the grommets -B-, -C-, and -F- for damage and proper seating.

-- Check the retaining points -A- for correct installation in the center tunnel and for damage.

-- Check the ball heads on air distribution housing -D-, which are inserted in retaining points -A-, for damage.

-- Check the outlets at the rear air distribution housing -D-, which are inserted in the air ducts -E-, and the air ducts -E- for damage and contamination.

-- Insert the rear air distribution housing -D- into the retaining points -A- and air ducts -E-.

-- Perform a basic setting for the A/C system. Refer to GENERAL INFORMATION AND PROCEDURES - ACTUATORS, REMOVING AND INSTALLING .