Rear A/C Display Control Head -E265-, REMOVING AND INSTALLING, "Mid" OR "Mix" A/C SYSTEM, Q8, PR NUMBER KH5/ 9AU: Installing

Install in reverse order of removal and note the following:

• Check that the locking tabs -3- are seated correctly with the trim -1-.
• So that the center armrest trims are not damaged, carefully insert the Rear A/C Display Control Head -E265- -2- in the support channels and then press it on.

-- After installing the Rear A/C Display Control Head -E265- check the DTC memory and if necessary erase. Use the Vehicle Diagnostic Tester.

-- If the Rear A/C Display Control Head -E265- is replaced, complete the test plan using the Vehicle Diagnostic Tester.