Thermal Management Control Module -J1024-, REMOVING AND INSTALLING
- If the Thermal Management Control Module -J1024- is replaced, before installing start the test plan for replacing the Thermal Management Control Module -J1024-. Use the Vehicle Diagnostic Tester.
Thermal Management Control Module -J1024-, Removing
-- Switch off (deactivate) the "parking air conditioner". Refer to Owner's Manual.
-- Switch off the ignition.
-- Removing the right front wheel housing liner. Refer to the appropriate service information .
-- Release and disconnect the connector -A-.
-- Release the retainer -A-, and remove the Thermal Management Control Module -J1024- -C- -arrow-.
Bracket for Thermal Management Control Module - J1024- (and Subframe Mount Control Module -J931-), Removing
-- Switch off (deactivate) the "parking air conditioner". Refer to Owner's Manual.
-- Switch off the ignition.
-- Remove the end panel on the right front fender. Refer to Fender (for accessibility to the screw -D-).
-- Remove the bolt -D-.
-- Removing the right front wheel housing liner. Refer to the appropriate service information .
-- Release and disconnect the connector -A-.
-- Release and disconnect the connector -B-.
-- Remove the bolt -C-.
-- Turn the bracket -F- (with the control module -E-) -arrow- and remove downward.
Installing
Install in reverse order of removal and note the following:
-- Check that the bracket -F- and the installed control modules are installed correctly.
-- Check that the connectors -A, B- are correctly seated and locked.
-- Retrieve the DTC memory and if necessary, delete the displayed faults using the Vehicle Diagnostic Tester.
-- If the Thermal Management Control Module -J1024- is replaced, complete the test plan using the Vehicle Diagnostic Tester.
Tightening Specifications
| Component | Tightening Specification |
|---|---|
| Bracket for the Thermal Management Control Module -J1024- to the body | 3 Nm |