Right Temperature Control Door Motor -V159-, REMOVING AND INSTALLING: Removing
-- On vehicles with high-voltage system, switch on the "parking air conditioner" function (deactivate). Refer to the Owner's Manual.
-- Move the right front seat all the way to the rear.
-- Switch off the ignition.
-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .
-- If equipped, remove the air duct for the glove compartment cooling. Refer to AIR DUCT FOR GLOVE COMPARTMENT COOLING, REMOVING AND INSTALLING .
-- Remove the right footwell vent. Refer to FRONT PASSENGER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .
Vehicles with a "Low" or "Mid" A/C system. PR number 9AD/ KH5
-- Remove the Right Side Vent Motor :V300 . Refer to Right Side Vent Motor -V300-, REMOVING AND INSTALLING .
Continuation for All Vehicles
-- Label the connector -C- and the actuator -B- (to avoid a mix up in case several connectors are disconnected at the same time).
-- Remove the bolts -A-.
-- Remove the actuator -B- from the door shaft -D-.
-- Release and disconnect the connector -C-.