Recirculation Door Motor -V113-, REMOVING AND INSTALLING: Removing
-- On vehicles with high-voltage system, switch on the "parking air conditioner" function (deactivate). Refer to the Owner's Manual.
-- Position the front passenger seat as far back as possible.
-- Switch off the ignition.
-- Remove the fastening plug -A-.
-- Loosen the footwell cover -B- from the heater and A/C unit air intake manifold and remove.
-- Label the connector -C- and the actuator -B- (to avoid a mix up in case several connectors are disconnected at the same time).
-- Remove the bolts -A-.
-- Remove the actuator -B- from the door shaft -D-.
-- Release and disconnect the connector -C-.