Audi e-tron GT (F8_) from MY 2022
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
| Vehicle | Required Adapters for the Connections to A/C Compressor | Necessary Adapter for the Connections to the Dryer / for the Check Valves and Shut-Off Valves | Miscellaneous |
|---|---|---|---|
| Audi e-tron GT (F8_) from MY 2022 | -- Compressor manufacturer "Sanden" (block connections with radial sealing)
|
Dryer-- Dryer removed and replaced by Refrigerant Circuit Adapter :VAS 6338/76 . Refer to DESICCANT BAG/DRYER CARTRIDGE, REMOVING AND INSTALLING . | -- If necessary, connect the additional Quick-Release Coupling, Low Pressure to the filler hose of the Flushing Device using a fitting Adapter.
|
| Vehicles with heat pump-- Removed the check valve and replaced by the Adapter :VAS 6338/47-1 from the Refrigerant Circuit Adapter Set :VAS 6338/47 . Refer to the appropriate service information . | Open or close the Adapter :VAS 6338/47-1 corresponding to the section to be flushed. Refer to Refrigerant Circuit (vehicle-specific Service Information). | ||
| Vehicles without heat pump-- Install the Adapter :VAS 6338/47-1 from the Refrigerant Circuit Adapter Set :VAS 6338/47 into the refrigerant line dryer/condenser. | Open or close the Adapter :VAS 6338/47-1 corresponding to the section to be flushed. Refer to Refrigerant Circuit (vehicle-specific Service Information). |
NOTE:
On this vehicle, the refrigerant circuit is flushed in three or four steps (flushing cycles) depending on the vehicle equipment. Refer to Refrigerant Circuit (A/C System Refrigerant Circuit, Cleaning).
The design of the different flushing circuits is described in the vehicle-specific Service Information. Refer to Refrigerant Circuit (Cleaning the A/C system refrigerant circuit).
After flushing the dryer must be replaced. Refer to DESICCANT BAG/DRYER CARTRIDGE, REMOVING AND INSTALLING .
Depending on the cause for the flushing procedure, further components must be replaced after flushing. This is described in the vehicle-specific Service Information. Refer to Refrigerant Circuit (clean the refrigerant circuit of the A/C system).