Seals And Gaskets
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- The sealing surfaces must be checked for burrs or damages before installing.
- Thoroughly clean the sealing surfaces before the assembly.
- The respective overview specifies if O-rings and seals must be replaced. If no overview is available, then these components must be replaced after removal.
- Make sure the O-rings are positioned correctly on the pipe or in the groove.
Unless otherwise specified:
- Coat the seals at the outer circumference with the respective medium (oil, coolant, refrigerant oil, etc.).
Shaft seals:
- Slightly coat the shaft seals in oil before installing at the outer diameter.
- The open side on the shaft seals faces the fluid to be sealed off.
- Specified shaft seals (for example PTFE) must be installed dry. For this, always pay attention to the repair Information.
- For shaft seals in the transmission area the space in between the sealing lips must be filled halfway with sealing grease.