Rear Lid Drive Unit -VX69- /Rear Lid Drive Unit 2 -VX77-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the D-pillar trim panel. Refer to D-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
-- Disconnect the connector -4-.
-- Have second technician support the rear lid.
-- Lightly pry up the locking spring -2- using a small screwdriver and remove the rear lid drive unit -1- from the ball pin -arrow- on the body and the rear lid.
-- Remove the grommet -3- from the body and guide the wiring harness out through the opening.