PREPARE THE Rear Lid Drive Unit -VX69- /Rear Lid Drive Unit 2 -VX77- FOR DISPOSAL.
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Commercially available metal saw
- Safety Gloves
- Protective Eyewear
- Cutter
Procedure
-- Clamp the drive unit with the engine-side -1- into a vise.
CAUTION:
There is a risk of injury from the knife and plastic particles in the air.
Eye irritation or injury could occur.
- Wear protective eyewear.
- Wear safety gloves.
-- Cut open and then remove the protective cover -3- using a sharp cutter -arrow-.
CAUTION:
Risk of eye injury due to flying shavings.
Eye irritation and injury is possible.
- Wear protective eyewear.
-- Separate the spring wire in distance -a- from the engine-side, using the Commercially Available Metal Saw.
- Dimension -a- = 100 mm (3.94 in.).
-- Turn the drive unit -1- and the spring half -2- into one another, in that way, the spring is released of tension.