Charge Door Unit, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

-- Open the cover of the left luggage compartment side trim panel and free up the emergency release cable.

-- Remove the charge door trim. Refer to FUEL FILLER DOOR TRIM, REMOVING AND INSTALLING .

-- Release the charge door unit by using a small screwdriver to pierce the markings -arrows-.

Courtesy of AUDI

-- At the top of the charge door unit, pierce a small screwdriver through the charge door markings over the retainers at an angle from below in the direction of -arrow-.

Courtesy of AUDI

-- Gently lift the screwdriver upward and release the retainers.

-- On the underside, pierce the screwdriver at the markings at an angle from above to below.

-- Gently push the screwdriver downward and release the retainers.

-- Pull the charge door unit out of the opening in stages.

-- Disconnect the connectors.

-- Remove the charge door unit, at the same time guide out the cable.