Overview - Wheel Bearing, AWD Vehicles

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Wheel Bearing

Courtesy of AUDI

Wheel Bearing Housing
- Removing and installing. Refer to WHEEL BEARING HOUSING, REMOVING AND INSTALLING .
Bolt
- 80 Nm + 90°
- Replace after removing
Drive Axle
Bolt
- 13 Nm
- Thread cutting
- Position the bolt by hand and tighten it until it finds the old threads. Then tighten the bolt to the specification.
Bracket
- For wires
Wheel Bearing
- Wheel Bearing Unit, Removing and Installing. Refer to WHEEL BEARING UNIT, REMOVING AND INSTALLING .
- Currently only delivered with -item 7-
- Wheel Bearing Unit, Servicing. Refer to WHEEL BEARING UNIT, SERVICING .
- Handling the wheel bearing. Refer to Figure.
Wheel Hub
- Currently only delivered with -item 6-
Bolt
- Drive Axle Threaded Connection, Loosening and Tightening. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .