Overview - Coil Spring
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- Rear Lower Transverse Link
- Removing and installing. Refer to REAR LOWER TRANSVERSE LINK, REMOVING AND INSTALLING .CAUTION:
If the coil spring breaks resulting in surface damage to the transverse link, then the transverse link must be replaced.
- Removing and installing. Refer to REAR LOWER TRANSVERSE LINK, REMOVING AND INSTALLING .
- Coil Spring
- Mark the installation direction with paint for reinstallation
- Removing and installing. Refer to SPRING, REMOVING AND INSTALLING .
- Installation position. Refer to Fig 2.
- Installation direction. Refer to Fig 3.
- Upper Spring Support
- Installation position. Refer to Fig 2.
- Lower Spring Support
- Installation position. Refer to Fig 2.
Coil Spring and Spring Plate Installation Position
- The end of the spring -1- must be positioned to the stop on the spring plates -2- -arrow-.
- The positioning pins of the spring plate must engage at the top in the holes in the body -3- and at the bottom in the holes in the rear transverse link -4- as shown.
Spring Installation Direction
- The tag on the spring with the part number -arrow- or the green marking must be installed upward.