Wheel Bearing Housing, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Slide the wheel bearing housing onto the drive axle splines.
-- Install the control arm. Refer to CONTROL ARM, REMOVING AND INSTALLING .
-- Install the upper control arm. Refer to UPPER CONTROL ARM, REMOVING AND INSTALLING .
-- Tighten the threaded connection between the drive axle and wheel hub. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .
- Overview table for when an axle alignment is needed. Refer to NEED FOR AXLE ALIGNMENT, EVALUATING .