Control Arm Ball Bearing, Replacing, Wheel Bearing Housing Side

Special tools and workshop equipment required 

• Press Plate:VW402 
  Fig 1: Press Plate VW402

  Courtesy of AUDI
• Press Piece - Multiple Use:VW412 
  Fig 2: Identifying Press Piece - Multiple Use VW412

  Courtesy of AUDI
• Press Piece - 42mm:VW516 
  Fig 3: Press Piece - 42 mm VW516

  Courtesy of AUDI
• Press Piece - Reverse Gear Syncro: 3296 
  Fig 4: Press Piece - Reverse Gear Syncro 3296

  Courtesy of AUDI
• Assembly Paste:G 052 109 A2 

Procedure

• The control arm is removed. Refer to CONTROL ARM, REMOVING AND INSTALLING .

Bonded Rubber Bushing, Pressing Out

Fig 5: Identifying Press-In Depth Mark

Courtesy of AUDI

-- Mark the press-in depth of the bonded rubber bushing -1- for example using a waterproof felt-tip pen -arrow-.

-- Arrange the special tools as shown.

-- Press out the bonded rubber bushing from the control arm -2-.

Bonded Rubber Bushing, Pressing In

Fig 6: Identifying Tool Set Up/Assembly

Courtesy of AUDI

-- Transfer the press-in depth mark from the old bonded rubber bushing to the new one.

-- Thinly coat the bonded rubber bushing with Assembly Paste:G 052 109 A2  .

-- Insert the bonded rubber bushing -1- in the control arm -2-.

-- Arrange the special tools as shown.

-- Press the bonded rubber bushing in the control arm, and do not tilt it.

-- Pay attention to the mark -arrow- for the press-in depth.

-- Check the press-in depth of the bonded rubber bushing -1- in the control arm -2-.

Fig 7: Identifying Installation Depth Dimensions

Courtesy of AUDI

• Specified value: dimension -a- = dimension -b-.

-- If the values are different, press in the bonded rubber bushing again.