Raising And Lowering With Open And Closed Air Suspension System
Raising with Air Suspension System Not Open
-- If the clearance for the hoist arms is insufficient, then set the vehicle to "lift" (highest level) before lifting the vehicle with the shop hoist and turn on the "vehicle lift mode".
This ensures that the hoist arms can pivot under the vehicle and the air suspension system will not make any unintended adjustments.
-- Position hoist lifting arms under intended lift points on longitudinal members and raise vehicle.
Lowering with Air Suspension System Not Closed
-- Lower hoist and place vehicle on wheels.
-- Swing back the hoist lifting arms.
-- Switch off "vehicle lift mode" and set the desired driving mode.
TIP:
"Vehicle lift mode" is automatically deactivated when vehicle speed exceeds 10 km/h (6.2 mph).
Lifting with the Air Suspension System Opened
- If the vehicle was lifted with the air suspension system open, then read the points in the sequence specified in "lowering with the air suspension system opened" before lowering the vehicle back onto it wheels.
Lowering with Open Air Suspension System
-- Connect all air lines to their corresponding components.
-- Fill the system. Refer to AIR SUSPENSION SYSTEM, FILLING AND BLEEDING .
-- Lower the vehicle onto its wheels.
-- Switch off "vehicle lift mode".
TIP:
"Vehicle lift mode" is automatically deactivated when vehicle speed exceeds 10 km/h (6.2 mph).