Exhaust Door Control Unit -J883- / Exhaust Door Control Unit 2 -J945-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2024 Audi SQ5 and 2023 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Replace the nuts after removing.
-- Bring the exhaust door control unit into its installed position
- The spring -2- must engage the groves of the exhaust flap -1-.
If the exhaust flap control unit has been replaced, carry out the adaptation.
-- Start diagnostic mode on the Vehicle Diagnostic Tester.
- Choose your own exam
- Drive V6 TFSI engine (repair group 01; 13-18)
- 01 - Self-diagnostic systems
- 01 - Engine electronics J623
- Electronic Components
- J883 - exhaust flap control unit or J945 - exhaust flap control unit 2
-- Start the selected program and follow the instructions on the vehicle diagnostic tester display.
After a successful actuator test start adaptation .