LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Cooling System (6-Cylinder Direct Injection 3.0L 4V TFSI Engine Ea839)) >> 19 Cooling System >> Coolant Pipes >> Coolant Pipes, Removing And Installing >> Left Front Coolant Pipe, Removing And Installing >> Removing

Left Front Coolant Pipe, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi SQ5 and 2023 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Remove the ribbed belt from the A/C compressor. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Remove the left front lower longitudinal member. Refer to Lock Carrier ; Lower Longitudinal Member, Removing and Installing.

-- Remove the A/C compressor from the bracket and tie it up on the left side. Refer to A/C COMPRESSOR, REMOVING AND INSTALLING FROM BRACKET .

-- Remove the lock carrier cover. Refer to Front Bumper .

-- Remove the bolts -arrows- and air duct -1-.

GWWA23-11115Courtesy of AUDI

-- Release the catches -arrows- and remove the air duct -2-.

GWWA19-12653Courtesy of AUDI

-- Remove the bolts -arrows- and remove the left front coolant pipe from the coolant pump.

GWWA19-12531Courtesy of AUDI