LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Cooling System (6-Cylinder Direct Injection 3.0L 4V TFSI Engine Ea839)) >> 19 Cooling System >> Coolant Pipes >> Coolant Pipes, Removing And Installing >> Large Right Rear Coolant Pipe, Removing And Installing >> Removing

Large Right Rear Coolant Pipe, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi SQ5 and 2023 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Remove the engine cover and heat shield. Refer to ENGINE COVER, REMOVING AND INSTALLING .

Vehicle without Parking Heater:

GWWA19-12534Courtesy of AUDI

-- Lift the clamp -1- and remove the coolant hose.

-- Push the retainer in direction of -arrow- and move the Coolant Recirculation Pump -V50- to the side.

-- Remove the nuts -arrows- and remove the bracket -1- for the Coolant Recirculation Pump -V50-.

GWWA15-12051Courtesy of AUDI

Continuation for All Vehicles:

GWWA19-12374Courtesy of AUDI

-- Remove the bolts -arrows-.

-- Loosen the hose clamp -2- and remove the coolant pipe -1-.