Engine Speed Sensor -G28-, REMOVING AND INSTALLING
WARNING: This page is about a different car, the 2024 Audi SQ5 and 2023 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear noise insulation. Refer to OVERVIEW - NOISE INSULATION .
-- Disconnect the connector -2-.
-- Remove the bolt -1- and the Engine Speed Sensor -G28-.
Installing
Install in the reverse order of removal while noting the following:
- Replace the O-rings after removing them.
Tightening Specifications
- Refer to OVERVIEW - IGNITION SYSTEM
- Refer to OVERVIEW - NOISE INSULATION .