Engine, Securing To Engine And Transmission Holder

Special tools and workshop equipment required 

• Engine and Transmission Holder:VAS6095A 
• Engine/Transmission Holder - Universal Mounting:VAS6095/1 
• Engine/Transmission Holder - V6 TFSI Bracket:VAS6095/1-15 

Procedure

-- Remove the bolts -arrows- and remove the left engine support.

Courtesy of AUDI

If the Chain Drive on the Connection Should Be Worked On:

Courtesy of AUDI

-- Remove the vacuum hose -2- at the same time to not damage it.

-- Free up the wiring harness -3-.

-- Remove the nuts -4- and bolt -5-.

-- Remove the vacuum reservoir -1-.

-- Remove the plug -1- for "TDC" hole and remove the bracket -2-.

Courtesy of AUDI

Continuation:

Courtesy of AUDI

-- Remove the ground cable nut -arrow-.

-- Remove the bolts -arrows- and remove the right engine support -1-.

Courtesy of AUDI

-- Remove the starter. Refer to STARTER, REMOVING AND INSTALLING .

-- Secure the engine to the :VAS6095A  using the :VAS6095/1-15  and :VAS6095/1-11  and tighten to 40 Nm.

Courtesy of AUDI