Engine, Removing From Scissor Lift Table
WARNING: This page is about a different car, the 2024 Audi SQ5 and 2023 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Lifting Tackle:3033
- Shop Crane:VAS6100
- Lift Arm Extension:VAS6101
Procedure
- Engine/transmission assembly removed and separated on :VAS6131B . Refer to ENGINE AND TRANSMISSION, SEPARATING .
-- Remove the ball pins -arrows- and then remove the heat shield -1-.
WARNING:
Risk of accident!
- The engine may only be transported in the manner described and without the transmission.
-- Attach the :VAS6101 to the :VAS6100 .
-- Engage the :3033 on the engine lifting eyes and on the shop crane as shown.
-- Pry up the engine with the workshop crane.