Right Lower Coolant Pipes On Longitudinal Member, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi Q8, 2021 Audi Q8, 2020 Audi Q8, and 2019 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Remove the rear noise insulation. Refer to NOISE INSULATION .

-- Place the :VAS5014 or :VAS6208 on the right side of the transmission area and under the subframe.

-- Clamp off the coolant hose -5- with :3094 -2-.

Fig 1: Coolant Pipe on Lower Longitudinal Member - Tightening Specifications

Courtesy of AUDI OF AMERICA, LLC

-- Lift the clamp -3-. Remove the coolant hose -6- and catch the leaking coolant.

-- Tie the coolant hose -6- upward on the transmission.

-- Loosen the hose clamp -4- and remove the coolant hose -5- from the coolant pipe -1-.

-- Remove the nuts -arrows- and remove the coolant line -1-.