Molded Foam Part, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

CAUTION:

Risk of damaging the pressure hose by deforming it.

- Never kink or stretch the pressure hose.

For Pressure Hoses without a Color Marking:

Courtesy of AUDI

-- Measure out and mark the center of the pressure hose.

-- Position the pressure hose -1- evenly in both directions in the recess in the molded foam part -3-.

Continuation:

CAUTION:

Pyrotechnical components can deploy unintentionally.

Risk of injury.

- Discharge the static electricity: quickly touch the door striker.

-- Engage the pedestrian protection crash sensor -2- into the molded foam part.

-- Attach the connector -1- to the crash sensor until it clicks into place in the direction of -arrow-.

Connector Lock on Pedestrian Protection Crash Sensor

Fig 1: Identifying Connector

Courtesy of AUDI

-- Push in the connector lock -2- to secure the connector.