Tie Rod, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

-- Remove the boot. Refer to BOOT, REMOVING AND INSTALLING .

-- Position the front wheels as follows:

For the left tie rod, turn the steering to the left until it stops
For the right tie rod, turn the steering to the right until it stops

-- Remove the spring clip with the Torque Wrench Insert - Open Jaw:V.A.G 1923 -2- by counterholding at the steering gear steering rack with an open end wrench -1-.

Fig 1: Removing Tie Rod

Courtesy of AUDI

CAUTION:

There is a risk of the steering gear being destroyed by moisture and dirt.

A visible film of grease present on the steering rack near the splines. If the film of grease is missing, replace the steering gear.