Tie Rod End, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Measuring Tie Rod Head / Tie Rod Dimension

Courtesy of AUDI

Install in the reverse order of removal while noting the following:

-- Screw the tie rod end -1- on the tie rod -2- until dimension -a-, which was measured during removal, is reached.

-- Align the tie rod end so that the pin is in the installation position.

-- Insert the tie rod end all the way into the wheel bearing housing.

-- Counterhold at the joint pin with a 6 mm hex socket wrench if necessary to tighten the nut -1-

Fig 2: Identifying Tie Rod End Joint Pin

Courtesy of AUDI

-- Tighten the nut -2-

Fig 3: Identifying Tie Rod End & Nut

Courtesy of AUDI

Overview table for when an axle alignment is needed. Refer to NEED FOR AXLE ALIGNMENT, EVALUATING .