Steering Gear, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

-- Bring wheels in the straight position.

-- Switch off the ignition.

-- Use the steering wheel locking device -2- to lock the steering wheel -1- when the wheels are in straight-ahead position.

Courtesy of AUDI

-- Remove the front wheels. Refer to WHEELS AND TIRES .

-- To protect the threads, remove the nut -arrow- from the tie rod end joint pin until it is flush with the joint pin threads.

Courtesy of AUDI

WARNING:

There is a risk of injury from falling components.

When pressing off, the tie rod end loosens abruptly from the wheel bearing housing. Place the Engine and Gearbox Jack:VAS 6931 for example underneath to secure.

CAUTION:

There is a risk of damaging the ball joint puller.

Make sure that both puller lever arms are parallel to each other when using maximum force.

-- Remove the tie rod end with the Ball Joint Splitter:VAS 251 805 from the wheel bearing housing.

-- Then remove the nut. Use a 6 mm inner hex socket to counterhold at the joint pin if necessary.

-- Repeat the procedure on the other side of the vehicle.

-- Remove the nuts -arrows- and the stabilizer bar.

Fig 1: Identifying Stabilizer Bar Components

Courtesy of AUDI

-- Remove the bolt -2-.

Courtesy of AUDI

-- Remove the universal joint -1- for the steering intermediate shaft from the steering gear -3-.

-- Lower the subframe crossbrace and do not press the guide link joint pin away from the conical seat while doing this. Refer to SUBFRAME CROSSBRACE, REMOVING AND INSTALLING .

CAUTION:

There is a risk of damaging the suspension components.

If the assembly mounts, the steering gear or the subframe crossbrace are not installed correctly, do not rest the vehicle on its wheels.
The vehicle must not be supported on the subframe or the subframe crossbrace (for example using a floor jack).

-- Release the safety catch, push the retainer down and disconnect the connectors -1 and 2- from the Power Steering Control Module -J500-.

Fig 2: Identifying Connector

Courtesy of AUDI

Fig 3: Identifying Steering Gear

Courtesy of AUDI

WARNING:

There is an accident risk due to the weight of the steering gear.

A second technician is required to remove the steering gear.

CAUTION:

Risk of damaging the boot.

The steering gear must not contact the boots during removal.

-- Remove the bolts -1 and 2- and the steering gear.