LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Passenger Protection, Airbags, Seat Belts) >> 69 Passenger Protection, Airbags, Seat Belts >> Seat Belt Fastening Detection >> Passenger Seat Occupant Detection Sensor -G128-, REMOVING AND INSTALLING >> Installing

Passenger Seat Occupant Detection Sensor -G128-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

NOTE:

Make sure the connectors are pushed in all the way and that they engage audibly.

If the Airbag Indicator Lamp -K75- indicates a fault after installing, check the DTC memory, erase it and check it again using the Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals