LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Passenger Protection, Airbags, Seat Belts) >> 69 Passenger Protection, Airbags, Seat Belts >> Battery Interrupt Igniter >> Battery Interrupt Igniter, Removing And Installing >> Battery Interrupt Igniter -N253-, REMOVING AND INSTALLING, 12 VOLT >> Installing

Battery Interrupt Igniter -N253-, REMOVING AND INSTALLING, 12 VOLT: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • The ignition must be on when connecting the battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone in the vehicle interior when connecting the battery.

Install in the reverse order of removal while noting the following:

NOTE:

Make sure the connectors are installed all the way and engage audibly.

WARNING:

The ignition must be on when connecting the battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone in the vehicle interior when connecting the battery.

-- Connect the battery ground cable with the ignition switched on. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Check the DTC memory for Airbag Control Module -J234- and correct any entries if necessary using the Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals