LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Seat Frames) >> 72 Seat Frames >> Rear Seats >> Bench Seat/Single Seat, Removing And Installing >> Bench Seat, Removing And Installing >> Removing

Bench Seat, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the front seats all the way forward.

-- Unclip the child seat anchor guides -1- from the anchors. Refer to LOWER CHILD SEAT ANCHOR GUIDE, REMOVING AND INSTALLING .

GWWA72-11652Courtesy of AUDI

-- Grab the bench seat -1- under the molded part -2- using both hands on one side.

GWWA72-12246Courtesy of AUDI

-- Using both hands on one side, forcefully pull the bench seat upward -arrow A- to release the molded part from the front mount -3-.

-- Repeat the procedure on the other side of the bench seat -arrow B-.

-- Alternating, from side to side, slightly lift up the bench seat -1-, press backward -A arrows- and at the same time press the rear downward -arrows B-.

GWWA72-12814Courtesy of AUDI

-- By this, the bracket -2- can be disengaged in the rear from the mounts of the child seat anchors -3- -arrow C-.

-- Lift the front of the bench seat slightly and remove it from under the backrest.

-- If equipped, disconnect the seat heating connector.

-- Remove the bench seat.