Additional Safety Precautions For Airbag Control Module
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- The "inertial sensor basic setting" must be performed after every removal and installation of the Airbag Control Module -J234-.
- If the Airbag Control Module -J234- is replaced with a new part, the basic setting is performed when implementing the "15 - Replace airbag control module" program.
- If the Airbag Control Module -J234- is removed and then the same one is reinstalled, perform the "inertial sensor basic setting" as follows:
-- Connect the Vehicle Diagnostic Tester.
-- Switch the ignition on.
-- Select and start the Diagnostic operating mode.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Body
- Body Assembly
- 0001 - OBD-capable systems
- 0015 - Airbag Control Module - J234
- 0015 - Airbag, functions
- 0015 - Basic setting
- 0015 - Inertial sensors basic setting
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.