Fiber-Optic Cable, Disconnecting From Wiring Harness Connector: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Releasing Catch In Fiber Optic Cable Connector Using Small Screw Driver

Courtesy of AUDI OF AMERICA, LLC

-- Unplug connector for fiber optic cable from appropriate control unit.

-- Release the catch in the fiber optic cable connector in direction of -arrow-.

-- Pull the fiber optic cable basic module -2- out of connector housing -1-.

Fig 2: Pulling Fiber Optic Cable Basic Module Out Of Connector Housing

Courtesy of AUDI OF AMERICA, LLC

Fig 3: Making Colored Dots To Mark Assignment Of Fiber Optic Cable To Corresponding Sockets In Basic Module

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Make colored dots to mark assignment of the fiber optic cable -5- to the corresponding sockets in the base module -1-.
Note the arrows -3- for allocation on the base module "IN" and "OUT".

-- Release the secondary catch -6- (blue pin) using a small screwdriver in direction of -arrow-.

-- Release the catch -2- and remove the fiber-optic cable -5- with brass connector pin -4- from the base module -1-.