Round Connector Systems

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts. Refer to SECONDARY LOCK .

-- Guide the release tool which fits the connector housing into release channel on connector housing.

Fig 1: Identifying Terminal At Wire Pushed Into Terminal Housing

Courtesy of AUDI OF AMERICA, LLC

-- Grasp contact at wire and push it gently into connector housing in direction of -arrow-.

NOTE:

By pushing the contact in the direction of the connector housing, contact retaining tabs are lifted off the housing shoulder and released using the release tool.

-- At the same time, push the release tool in the direction of the connector housing -arrow- and pull the released contact out of the connector housing.

-- After removing the contact, release tool can be pulled out of the connector housing again.

Fig 2: Identifying Released Terminal Pulled Out From Terminal Housing

Courtesy of AUDI OF AMERICA, LLC