LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Battery, Starter, Generator, Cruise Control) >> 27 Battery, Starter, Generator, Cruise Control >> Starter >> Starter, Removing And Installing >> Starter, Removing And Installing, Vehicles With 4-Cylinder Engine >> Removing

Starter, Removing And Installing, Vehicles With 4-Cylinder Engine: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING .

Vehicles with 2.0L TDI engine EA 288 evo:

-- Remove the particulate filter. Refer to PARTICULATE FILTER, REMOVING AND INSTALLING .

Continuation for All Vehicles:

-- Remove the right engine support. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .

-- Remove the bolt -arrow-.

Fig 1: Identifying Plenum
GWWA27-10286Courtesy of AUDI

-- Remove the bolt -5- and nut -4-.

Fig 2: Identifying Starter Overview
GWWA27-10287Courtesy of AUDI

-- Remove the starter -item 1-, disconnect the connector -3- and free up the B+ wire -2-.