BATTERY TEST WITH Vehicle Diagnostic Tester
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
NOTE:
The Battery -A- can also be checked while it is installed without the connected battery charger on vehicles with Battery Monitoring Control Module -J367- or Energy Management Control Module -J644- and Data Buson Board Diagnostic Interface -J533- using the Vehicle Diagnostic Tester.
Test Prerequisites
- No battery charger connected
- Battery -A- is connected.
- Battery temperature at least +10 °C (50 °F).
Procedure
Vehicle Diagnostic Tester is attached.
-- Select the Diagnostic mode and start the diagnostics.
-- Select the tab Test Plan .
-- Select Select Individual Tests and choose the following sequence.
- Body
- Electrical Equipment
- 27 - Starter, voltage supply
- Electrical Components
- A - Battery, Checking
The Vehicle Diagnostic Tester continues with the battery test from here on.