Brake Pad Wear Indicator Wire, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- Check the brake pad wear indicator contact for damage and replace if necessary.
- Make sure that the brake pad wear indicator contact fits correctly in the brake pad.
- If the clips go missing, the brake pad wear indicator wire must be replaced.
-- Insert the contact -1- for the brake pad wear indicator with the clip -2- until it engages in the inner brake pad.
-- Secure the brake pad wear indicator wire with the protective cap -3- and the clip -4-.
-- Bring the connector -1- into its installation position and turn in the direction of -arrow- until the tab -3- engages in the hole -4- on the bracket.
-- Connect the connector -2-.