Left And Right Parking Brake Motor -V282- / -V283-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Replace the seal after removal.
The ring groove for the gasket and the parking brake motor contact surface must not be damaged.

-- Clean the parking brake motor ring groove and contact surface.

-- Install the new seal.

TIP:

Make sure that the gasket is not removed while assembling the parking brake motor.

-- Bring the parking brake motor -1- into the installation position while turning the parking brake motor back and forth slightly.

Courtesy of AUDI

-- Tighten the bolts -arrows-.

The parking brake motor must be flush with the brake caliper. Under no circumstances may it be pulled against the brake caliper with bolts.

CAUTION:

Risk of damaging the threads due to improper handling.

- Never use an impact wrench to loosen or tighten.

- Position the bolts by hand and screw in the first threads.

-- After installation, select the "Electromechanical Parking Brake Control Module - J540" program. Refer to DIAGNOSTIC ENTRIES .

-- Follow the instructions in the Vehicle Diagnostic Tester display.

CAUTION:

Faulty brakes increase the risk of an accident.

- Make sure the brakes are working correctly before driving the vehicle for the first time.