Vehicle Transport Mode, Deactivating
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Procedure:
-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .
-- Select the Diagnostic mode and start the diagnosis.
-- Perform the vehicle identification.
-- Set v and press Accept to select "Work with Guided Fault Finding".
The control module identification and checking the DTC memory occurs next. Observe the instructions and test conditions.
-- Switch to the "Control modules" tab and open the "DTC memory list" to view all of the stored DTC memory entries.
-- Change to the "test plan" tab and perform the specified test programs.