Diagnostic Procedures, Performing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Procedure:

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Select the Diagnostic mode and start the diagnosis.

-- Perform the vehicle identification.

-- Remove the checkmark "Procedures with Guided Fault Finding".

-- Switch to the "Special Functions" tab and select the following program:

Entire pre-delivery inspection

-- Start the program using Perform test... .

-- Follow and complete the program sequence.

-- Switch to the "Control modules" tab and press the "Guided Fault Finding" button and perform the Guided Fault Finding through to the test plan.

-- The static entries in the DTC memory must be evaluated and corrected using Guided Fault Finding if necessary.

-- Perform diagnostics; a diagnostic log for the pre-delivery inspection will be automatically sent.