Lock Set, Replacement Procedure
If the vehicle receives a new lock set and a new identity, the Steering Column Lock Actuator -N360- (electronic steering column lock) can only be adapted once the Access/Start Authorization Control Module -J518- has learned the new identity. Otherwise, the electronic steering column lock can no longer learn if it is already adapted and it cannot be used.
Immobilizer Generation 1, 2 and 3.
-- Perform in the "Off-board Diagnostic Information System Service" the function "vehicle key adaptation" or "vehicle key, immobilizer programing" from the Vehicle Diagnostic Tester.
-- All vehicle keys must be adapted.
- For anti-theft immobilizer generation 3, the Engine/Motor Control Module -J623- and the Instrument Cluster Combination Processor -J218- or the Instrument Cluster Control Module -J285- must also be replaced when replacing the lock set.
Immobilizer Generation 4
-- Perform in the "Off-board Diagnostic Information System Service" the "immobilizer activating/new identity" or "New Identity" in the Vehicle Diagnostic Tester.
-- All vehicle keys must be adapted.
Immobilizer from Generation 5
-- Perform in the "Off-board Diagnostic Information System Service" the "immobilizer, servicing" and adapt the program to the vehicle key in the Vehicle Diagnostic Tester.
-- All vehicle keys must be adapted.