Roof Opening Seal, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- The vehicle and the seal must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
- If the Bonding Agent:D 355 205A2 dries longer than 3 hours, then it must be primed again.
- Do not stretch the seal when installing it.
-- Clean the adhesive surface using the Cleaning Solution:D 009 401 04 .
-- Apply Bonding Agent:D 355 205A2 on the adhesive surface using the Applicator:D 009 500 25 and let dry.
-- Place the rear seal in the center of the roof all around on the edge -3- of the sunroof opening at the same time evenly remove the protective film from the adhesive strip -2-.
- The seal must be flush on the roof surface.
- Maximum height difference -a- = ± 0.5 mm.
-- Press the seal onto the roof edge by going over it twice with the :3356 .
-- Install the front and rear glass panel. Refer to GLASS PANEL, REMOVING AND INSTALLING .