Glass Panel Seal, Removing And Installing, Front: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

The vehicle and seal must be at room temperature.
The adhesive surfaces must be free of dirt and grease.
If the Bonding Agent:D 355 205A2 dries longer than 3 hours, then it must be primed again.

-- Clean the adhesive surface using the Cleaning Solution:D 009 401 04 .

-- Apply Bonding Agent:D 355 205A2 on the adhesive surface using the Applicator:D 009 500 25 and let dry.

-- Remove the protective film from the adhesive surface.

-- Apply the seals in the opening on the glass panel.