LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Sunroof (Fy)) >> 60 Sunroof >> Sliding Sunroof >> Glass Panel, Removing And Installing >> Glass Panel, Removing And Installing, Front >> Removing

Glass Panel, Removing And Installing, Front: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Moving the slotted guide rail guide increases the risk of damaging the sliding sunroof components.

- Move the slotted guide rail guide only when the glass panel is installed.

-- Open the glass panel just far enough until the trim is accessible.

-- Remove the trim from the front edge and pull it all the way toward the rear -arrow A-.

GWWA60-10605Courtesy of AUDI

-- Pull the trim on the rear edge slightly toward the inside to disengage the locking bracket -1- -arrow B-.

-- Push the trim toward the front -arrow C- and disengage the locking pins -2 and 3-.

-- Remove the trim.

-- Remove the left and right bolts -arrows- and the front glass panel -1-.

Fig 1: Removing Both Left And Right Front Screws On Glass Panel
GWWA60-10243Courtesy of AUDI