Carpet, Removing And Installing: Removing
-- Remove the front seats. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Remove the center console. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .
-- Remove the footwell cover on the driver side. Refer to DRIVER SIDE FOOTWELL COVER, REMOVING AND INSTALLING .
-- Remove the footrest. Refer to FOOTREST, REMOVING AND INSTALLING .
-- Remove the A-pillar lower trim panels. Refer to LOWER A-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
-- Remove the bench seat / bucket seats. Refer to BENCH SEAT/SINGLE SEAT, REMOVING AND INSTALLING .
-- Remove the sill panels. Refer to SILL PANEL, REMOVING AND INSTALLING .
-- Remove the B-pillar lower trim panels. Refer to B-PILLAR LOWER TRIM PANEL, REMOVING AND INSTALLING .
-- Remove the nuts -1- and -3- and remove the retaining bracket.
-- If installed, remove the air duct for the rear vent.
-- Remove the floor mats.
-- If necessary, free up the carpet at the front of the center tunnel -arrows- and in the instrument panel crossmember area.
-- Lift the rear carpet -1- and pull it toward the rear -arrows-.
-- Fold and remove the carpet in the center.
Make sure the carpet does not tear at the openings.